| Table of Contents |
|---|
| Page Properties | ||
|---|---|---|
| ||
Introduction
This article describes the most common reasons for which terms might not be highlighted in XTM Workbench. As you will see in the next section, certain conditions at XTM Cloud configuration level must be met first.
...
You might be wondering why the terms in a project are not highlighted in blue immediately after you create the a project and open XTM Workbench. The solution (administrative privileges required!) is to enable the Match terms in analysis option in Configuration → Settings → Translation → Terminology → Terminology engines → Match terms in analysis.
...
To learn how stemming works, we recommend that you read this article: Stemming.
To enable the highlighting of stemmed words in XTM Workbench, you need to select the Highlight all term variants option in Configuration → Settings → Translation → Terminology → Terminology options → Highlight all term variants.
...
If you want the terms that have no translations to be highlighted in XTM Workbench, you need to select the Decorate terms without translations option in Configuration → Settings → Translation → Terminology → Terminology options → Decorate terms without translations.
...
It is important to note the difference between two terminology-related options that can be found in the QA profile’s settings:
 |
|---|
Language combination
You can set up language combinations globally or per customer and the related configuration is very important in ensuring that terms are highlighted correctly in XTM Workbench.
...
Remember that stop words are not highlighted in XTM Workbench by default. To learn what stop words actually are and to see a full list of them, we recommend that you read this article: What are stop words?.