| Table of Contents |
|---|
| Page Properties | ||
|---|---|---|
| ||
Introduction
You might sometimes want to send some additional files through XTM Cloud, as reference for AEM end users, along with standard translation items. This is unusual, but it is possible. Those files are not meant to be translated, as they only contain subsidiary material (guidelines, descriptions, etc.).
...
On the XTM Cloud side, go to Configuration → Settings → Workflow → Workflow options, check Workflow for non-analysable files, and save the changes(administrative privileges required!).
...
...
On the AEM side, go to Adobe Experience Manager → Navigation → Assets.
...
...
Go to Files.
...
...
On the right-hand side, click Create, and then select Folder.
...
...
Enter a Title, and then click Create. Both Private and Orderable options can be deselected.
...
...
Check a newly created folder, click on Create, and then select Files.
...
...
Upload a PDF file without content (this is our dummy file). XTM Cloud will treat it as a non-analyzable file.
...
Go back to Adobe Experience Manager → Navigation, and go to Projects.
...
...
Click on Create, and then select Project.
...
...
Select Translation Project, and then click Next.
...
...
Fill in the project details in the Basic and Advanced tabs, and then click on Create.
...
...
Click Open.
...
...
In the Translation Job pane, click on three dots at the bottom.
...
...
Click on Add, and then select Assets/Pages.
...
...
Add the source content that is to be translated and the dummy file you created in the previous steps.
...
Once the files have been added, click on Translation Job in the middle of the tab screen, and go back to your project.
...
...
Expand the dropdown in Translation Job and send the project to XTM Cloud in your usual way.
...
...
On the XTM Cloud side (Project editor → Workflow), you will see that the dummy file was not analyzed.
...
Such a file is not present in the Files section, and we cannot manually upload target to it.
...
...
By enabling “workflow for non-analazyble files”, we can make use of the Set workflow option.
...
Since this is a file without any translatable content, the Set workflow option will “bypass” the process of converting it into editable “DOCX” format, so it will remain in “PDF” format.
...
20.
Choose the required workflow,and then click OK.
...
...
A newly created workflow for this dummy file is displayed.
If you will want to finish that job immediately after uploading a file, you need to assign some resources here, immediately.
...
...
Go to Files. In the Target column, you will see that the actual target file can now be uploaded.
...
23.
Search for your file and then click Upload.
...
| Note |
|---|
IMPORTANT! The name of your uploaded file must be the same as the name of the dummy file in XTM Cloud! |
...
You should receive a confirmation message.
...
...
Go back to Workflow, and finish the job by going through all the workflow steps.
...
...
On the AEM side, go back to the relevant project, and, in the Translation Job pane, click three dots.
...
...
Your PDF file has already been returned to AEM. Select the file, and then click on Reveal in Assets.
...
...
Click on Download.
...
...
Enter a name, select desirable options, and finally click on Download to confirm the process.
...
...
Congratulations! You should now receive your additional PDF file from XTM Cloud.