Introduction

When you are working on a specific project in XTM Cloud, you might sometimes realize that you are trying to edit the translation in the Review workflow step, although the purpose of that workflow step is slightly different from editing. The purpose of this article is to describe the Review step in its entirety.

...

What you can

...

and

...

cannot do in the Review step

General information

In general, as the name of this workflow step suggests, the Review workflow step is primarily for reviewing a translation. The review is performed after the translation has been produced (usually in the Translate step), and then corrected (usually in the Correct step), by adding comments to it in relevant segments in XTM Workbench. Therefore, the difference between the Review workflow step and the other project workflow steps is that users can (primarily) enter comments about translations in the Review workflow step, but they cannot edit the translation in any way.

Below, you will find details about what can and cannot be done in the Review step.

What can you do?

In the Review workflow step you can:

...

• change a segment’s status in XTM Workbench.

...

What can you not do?

In the Review workflow step you cannot:

...